Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 371
:SAVE:WAVeform:LENGth
(see page 658)
Command Syntax
:SAVE:WAVeform:LENGth <length>
<length> ::= 100 to max. length; an integer in NR1 format
The :SAVE:WAVeform:LENGth command sets the waveform data length
(that is, the number of points saved).
Query Syntax
:SAVE:WAVeform:LENGth?
The :SAVE:WAVeform:LENGth? query returns the specified waveform data
length.
Return Format
<length><NL>
<length> ::= 100 to max. length; an integer in NR1 format
See Also • "Introduction to :SAVE Commands" on page 358
• ":SAVE:WAVeform[:STARt]" on page 369
• ":WAVeform:POINts" on page 512
• ":SAVE:WAVeform:FORMat" on page 370
To Next Page
Loading...
