458 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:TRIGger:IIC[:SOURce]:DATA
(see page 658)
Command Syntax
:TRIGger:IIC:[SOURce:]DATA <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital0,..,DIGital15} for the MSO models
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :TRIGger:IIC:[SOURce:]DATA command sets the source for IIC serial
data (SDA).
Query Syntax
:TRIGger:IIC:[SOURce:]DATA?
The :TRIGger:IIC:[SOURce:]DATA? query returns the current source for IIC
serial data.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 411
• ":TRIGger:IIC[:SOURce]:CLOCk" on page 457
To Next Page
Loading...
