Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 233
:FUNCtion:GOFT:OPERation
(see page 658)
Command Syntax
:FUNCtion:GOFT:OPERation <operation>
<operation> ::= {ADD | SUBTract | MULTiply}
The :FUNCtion:GOFT:OPERation command sets the math operation for the
g(t) source that can be used as the input to the FFT, INTegrate,
DIFFerentiate, or SQRT functions:
• ADD — Source1 + source2.
• SUBTract — Source1 - source2.
• MULTiply — Source1 * source2.
The :FUNCtion:GOFT:SOURce1 and :FUNCtion:GOFT:SOURce2 commands
are used to select source1 and source2.
Query Syntax
:FUNCtion:GOFT:OPERation?
The :FUNCtion:GOFT:OPERation? query returns the current g(t) source
operation setting.
Return Format
<operation><NL>
<operation> ::= {ADD | SUBT | MULT}
See Also • "Introduction to :FUNCtion Commands" on page 230
• ":FUNCtion:GOFT:SOURce1" on page 234
• ":FUNCtion:GOFT:SOURce2" on page 235
• ":FUNCtion:SOURce1" on page 241
To Next Page
Loading...
