To Next Page

To Previous Page

576 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

7 Obsolete and Discontinued Commands

:FUNCtion:SOURce

(see page 658)

Command Syntax

:FUNCtion:SOURce <value>

<value> ::= {CHANnel<n> | ADD | SUBTract | MULTiply}

<n>::={1|2|3|4}forthefour channel oscilloscope models

<n> ::= {1 | 2} for the two channel oscilloscope models

The :FUNCtion:SOURce command is only used when an FFT (Fast Fourier

Transform), DIFF, or INT operation is selected (see

the:FUNCtion:OPERation command for more information about selecting an

operation). The :FUNCtion:SOURce command selects the source for

function operations. Choose CHANnel<n>, or ADD, SUBT, or MULT to

specify the desired source for function DIFFerentiate, INTegrate, and FFT

operations specified by the :FUNCtion:OPERation command.

Query Syntax

:FUNCtion:SOURce?

The :FUNCtion:SOURce? query returns the current source for function

operations.

Return Format

<value> ::= {CHAN<n> | ADD | SUBT | MULT}

<n>::={1|2|3|4}forthefour channel oscilloscope models

<n> ::= {1 | 2} for the two channel oscilloscope models

See Also • "Introduction to :FUNCtion Commands" on page 230

• ":FUNCtion:OPERation" on page 237

NOTE

The :FUNCtion:SOURce command is an obsolete command provided for compatibility to

previous oscilloscopes. Use the :FUNCtion:SOURce1 command (see page 241) instead.

Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 5000 Series