Agilent Technologies InfiniiVision 5000 Series

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 483
:TRIGger:TV:SOURce
(see page 658)
Command Syntax
:TRIGger:TV:SOURce <source>
<source> ::= {CHANnel<n>}
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :TRIGger:TV:SOURce command selects the channel used to produce the
trigger.
Query Syntax
:TRIGger:TV:SOURce?
The :TRIGger:TV:SOURce? query returns the current TV trigger source.
Return Format
<source><NL>
<source> ::= {CHAN<n>}
See Also • "Introduction to :TRIGger Commands" on page 411
• ":TRIGger:MODE" on page 417
• ":TRIGger:TV:POLarity" on page 482
Example Code • "Example Code" on page 444