Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

394 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:SYSTem:ERRor
(see page 658)
Query Syntax
:SYSTem:ERRor?
The :SYSTem:ERRor? query outputs the next error number and text from
the error queue. The instrument has an error queue that is 30 errors deep
and operates on a first- in, first- out basis. Repeatedly sending the
:SYSTem:ERRor? query returns the errors in the order that they occurred
until the queue is empty. Any further queries then return zero until
another error occurs.
Return Format
<error number>,<error string><NL>
<error number> ::= an integer error code in NR1 format
<error string> ::= quoted ASCII string containing the error message
Error messages are listed in "Error Messages" on page 615.
See Also • "Introduction to :SYSTem Commands" on page 391
• "*ESR (Standard Event Status Register)" on page 104
• "*CLS (Clear Status)" on page 101

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English