Agilent Technologies InfiniiVision 5000 Series

To Next Page

To Previous Page

Commands by Subsystem 5

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 255

:HARDcopy:STARt

(see page 658)

Command Syntax

:HARDcopy:STARt

The :HARDcopy:STARt command starts a print job.

See Also • "Introduction to :HARDcopy Commands" on page 246

• ":HARDcopy:APRinter" on page 248

• ":HARDcopy:PRINter:LIST" on page 254

• ":HARDcopy:FACTors" on page 249

• ":HARDcopy:FFEed" on page 250

• ":HARDcopy:INKSaver" on page 251

• ":HARDcopy:LAYout" on page 252

• ":HARDcopy:PALette" on page 253

Other manuals for Agilent Technologies InfiniiVision 5000 Series