Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 323
:MTESt:AMASk:CREate
(see page 658)
Command Syntax
:MTESt:AMASk:CREate
The :MTESt:AMASk:CREate command automatically constructs a mask
around the current selected channel, using the tolerance parameters
defined by the :MTESt:AMASk:XDELta, :MTESt:AMASk:YDELta, and
:MTESt:AMASk:UNITs commands. The mask only encompasses the portion
of the waveform visible on the display, so you must ensure that the
waveform is acquired and displayed consistently to obtain repeatable
results.
The :MTESt:SOURce command selects the channel and should be set before
using this command.
See Also • "Introduction to :MTESt Commands" on page 320
• ":MTESt:AMASk:XDELta" on page 326
• ":MTESt:AMASk:YDELta" on page 327
• ":MTESt:AMASk:UNITs" on page 325
• ":MTESt:AMASk:SOURce" on page 324
• ":MTESt:SOURce" on page 349
Example Code • "Example Code" on page 320
To Next Page
Loading...
