Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

602 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
7 Obsolete and Discontinued Commands
:MTESt:LOAD
(see page 658)
Command Syntax
:MTESt:LOAD "<filename>"
The :MTESt:LOAD command loads the specified mask file.
The <filename> parameter is an MS- DOS compatible name of the file, a
maximum of 254 characters long (including the path name, if used).
See Also • "Introduction to :MTESt Commands" on page 320
• ":MTESt:AMASk:{SAVE | STORe}" on page 599
NOTE
The :MTESt:LOAD command is obsolete and is provided for backward compatibility to
previous oscilloscopes. Use the :RECall:MASK[:STARt] command (see page 354) instead.

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English