Agilent Technologies InfiniiVision 5000 Series

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 473
:TRIGger:SPI:FRAMing
(see page 658)
Command Syntax
:TRIGger:SPI:FRAMing <value>
<value> ::= {CHIPselect | NOTChipselect | TIMeout}
The :TRIGger:SPI:FRAMing command sets the SPI trigger framing value. If
TIMeout is selected, the timeout value is set by the
:TRIGger:SPI:CLOCk:TIMeout command.
Query Syntax
:TRIGger:SPI:FRAMing?
The :TRIGger:SPI:FRAMing? query returns the current SPI framing value.
Return Format
<value><NL>
<value> ::= {CHIPselect | NOTChipselect | TIMeout}
See Also • "Introduction to :TRIGger Commands" on page 411
• ":TRIGger:MODE" on page 417
• ":TRIGger:SPI:CLOCk:TIMeout" on page 472
• ":TRIGger:SPI:SOURce:FRAMe" on page 478