Agilent Technologies InfiniiVision 5000 Series

To Next Page

To Previous Page

Commands by Subsystem 5

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 477

:TRIGger:SPI:SOURce:DATA

(see page 658)

Command Syntax

:TRIGger:SPI:SOURce:DATA <source>

<source> ::= {CHANnel<n> | EXTernal} for the DSO models

<source> ::= {CHANnel<n> | DIGital0,..,DIGital15} for the MSO models

<n>::={1|2|3|4}forthefour channel oscilloscope models

<n> ::= {1 | 2} for the two channel oscilloscope models

The :TRIGger:SPI:SOURce:DATA command sets the source for the SPI serial

data.

Query Syntax

:TRIGger:SPI:SOURce:DATA?

The :TRIGger:SPI:SOURce:DATA? query returns the current source for the

SPI serial data.

Return Format

See Also • "Introduction to :TRIGger Commands" on page 411

• ":TRIGger:SPI:SOURce:CLOCk" on page 476

• ":TRIGger:SPI:SOURce:FRAMe" on page 478

• ":TRIGger:SPI:PATTern:DATA" on page 474

• ":TRIGger:SPI:PATTern:WIDTh" on page 475

Other manuals for Agilent Technologies InfiniiVision 5000 Series