610 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
7 Obsolete and Discontinued Commands
:TRIGger:CAN:ACKNowledge
(see page 658)
Command Syntax
:TRIGger:CAN:ACKNowledge <value>
<value> ::= {0 | OFF}
This command was used with the N2758A CAN trigger module for
54620/54640 Series mixed- signal oscilloscopes. The InfiniiVision
5000 Series oscilloscopes do not support the N2758A CAN trigger module.
Query Syntax
:TRIGger:CAN:ACKNowledge?
The :TRIGger:CAN:ACKNowledge? query returns the current CAN
acknowledge setting.
Return Format
<value><NL>
<value> ::= 0
See Also • "Introduction to :TRIGger Commands" on page 411
• ":TRIGger:MODE" on page 417
• ":TRIGger:CAN:TRIGger" on page 431
To Next Page
Loading...
