To Next Page

To Previous Page

448 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

5 Commands by Subsystem

:TRIGger:GLITch:LEVel

(see page 658)

Command Syntax

:TRIGger:GLITch:LEVel <level_argument>

<level_argument> ::= <level>[, <source>]

<level> ::= .75 x full-scale voltage from center screen in NR3 format

for internal triggers

<level> ::= ±(external range setting) in NR3 format

for external triggers

<source> ::= {CHANnel<n> | EXTernal}

<n>::={1|2|3|4}forthefour channel oscilloscope models

<n> ::= {1 | 2} for the two channel oscilloscope models

The :TRIGger:GLITch:LEVel command sets the trigger level voltage for the

active pulse width trigger.

Query Syntax

:TRIGger:GLITch:LEVel?

The :TRIGger:GLITch:LEVel? query returns the trigger level of the current

pulse width trigger mode. If all channels are off, the query returns

"NONE."

Return Format

<level_argument><NL>

See Also • "Introduction to :TRIGger Commands" on page 411

• ":TRIGger:MODE" on page 417

• ":TRIGger:GLITch:SOURce" on page 452

• ":EXTernal:RANGe" on page 226

Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 5000 Series