Agilent Technologies InfiniiVision 5000 Series

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 159
:STATus
(see page 658)
Query Syntax
:STATus? <source>
<source> ::= {CHANnel<n> | FUNCtion | MATH | SBUS}
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :STATus? query reports whether the channel, function, or serial
decode bus specified by <source> is displayed.
Return Format
<value><NL>
<value> ::= {1 | 0}
See Also • "Introduction to Root (:) Commands" on page 124
• ":BLANk" on page 130
• ":CHANnel<n>:DISPlay" on page 194
• ":FUNCtion:DISPlay" on page 232
• ":SBUS:DISPlay" on page 380
• ":VIEW" on page 162
NOTE
MATH is an alias for FUNCtion.