Agilent Technologies InfiniiVision 5000 Series

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 455
:TRIGger:IIC:PATTern:DATA
(see page 658)
Command Syntax
:TRIGger:IIC:PATTern:DATA <value>
<value> ::= integer or <string>
<string> ::= "0xnn" where n ::= {0,..,9 | A,..,F}
The :TRIGger:IIC:PATTern:DATA command sets IIC data. The data value
can range from 0x00 to 0x0FF (hexadecimal). Use the don't care data
pattern (- 1 or 0xFFFFFFFF) to ignore the data value.
Query Syntax
:TRIGger:IIC:PATTern:DATA?
The :TRIGger:IIC:PATTern:DATA? query returns the current pattern for IIC
data.
Return Format
<value><NL>
See Also • "Introduction to :TRIGger Commands" on page 411
• ":TRIGger:IIC:PATTern:ADDRess" on page 454
• ":TRIGger:IIC:PATTern:DATa2" on page 456
• ":TRIGger:IIC:TRIGger[:TYPE]" on page 460