Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 525
:WAVeform:SOURce:SUBSource
(see page 658)
Command Syntax
:WAVeform:SOURce:SUBSource <subsource>
<subsource> ::= {{NONE | RX} | TX}
If the :WAVeform:SOURce is SBUS (serial decode), more than one data set
may be available, and this command lets you choose from the available
data sets.
Currently, only UART serial decode lets you get "TX" data. The default,
NONE, specifies "RX" data. (RX is an alias for NONE.)
If the :WAVeform:SOURce is not SBUS, or the :SBUS:MODE is not UART,
the only valid subsource is NONE.
Query Syntax
:WAVeform:SOURce:SUBSource?
The :WAVeform:SOURce:SUBSource? query returns the current waveform
subsource setting.
Return Format
<subsource><NL>
<subsource> ::= {NONE | TX}
See Also • "Introduction to :WAVeform Commands" on page 502
• ":WAVeform:SOURce" on page 521

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English