Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 3
In This Book
This book is your guide to programming the 5000 Series oscilloscopes:
The first few chapters describe how to set up and get started:
• Chapter 1, "What's New" on page 19, describes programming command
changes in the latest version of oscilloscope software.
• Chapter 2, "Setting Up" on page 31, describes the steps you must take
before you can program the oscilloscope.
• Chapter 3, "Getting Started" on page 41, gives a general overview of
oscilloscope program structure and shows how to program the
oscilloscope using a few simple examples.
• Chapter 4, "Commands Quick Reference" on page 55, is a brief listing of
the 5000 Series oscilloscope commands and syntax.
The next chapters provide reference information:
• Chapter 5, "Commands by Subsystem" on page 95, describes the set of
commands that belong to an individual subsystem and explains the
function of each command. Command arguments and syntax are
described. Some command descriptions have example code.
• Chapter 6, "Commands A- Z" on page 535, contains an alphabetical
listing of all command elements.
• Chapter 7, "Obsolete and Discontinued Commands" on page 563,
describes obsolete commands which still work but have been replaced
by newer commands and discontinued commands which are no longer
supported.
• Chapter 8, "Error Messages" on page 615, lists the instrument error
messages that can occur while programming the oscilloscope.
The command descriptions in this reference show upper and lowercase
characters. For example, :AUToscale indicates that the entire command
name is :AUTOSCALE. The short form, :AUT, is also accepted by the
oscilloscope.
Then, there are chapters that describe programming topics and conceptual
information in more detail:
• Chapter 9, "Status Reporting" on page 623, describes the oscilloscope's
status registers and how to check the status of the instrument.
Table 1 InfiniiVision 5000 Series Oscilloscope Models
Channels Input Bandwidth (Maximum Sample Rate)
500 MHz (4 GSa/s) 300 MHz (2 GSa/s) 100 MHz (2 GSa/s)
4 analog DSO5054A DSO5034A DSO5014A
2 analog DSO5052A DSO5032A DSO5012A

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English