Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

4 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
• Chapter 10, "Synchronizing Acquisitions" on page 647, describes how to
wait for acquisitions to complete before querying measurement results
or performing other operations with the captured data.
• Chapter 11, "More About Oscilloscope Commands" on page 657, contains
additional information about oscilloscope programming commands.
Finally, there is a chapter that contains programming examples:
• Chapter 12, "Programming Examples" on page 679.
See Also • For more information on using the SICL, VISA, and VISA COM libraries
in general, see the documentation that comes with the Agilent IO
Libraries Suite.
• For information on controller PC interface configuration, see the
documentation for the interface card used (for example, the Agilent
82350A GPIB interface).
• For information on oscilloscope front-panel operation, see the User's
Guide.
• For detailed connectivity information, refer to the Agilent Technologies
USB/LAN/GPIB Connectivity Guide. For a printable electronic copy of
the Connectivity Guide, direct your Web browser to "www.agilent.com"
and search for "Connectivity Guide".
• For the latest versions of this and other manuals, see:
"http://www.agilent.com/find/5000manual"

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English