Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 263
:MARKer:XDELta
(see page 658)
Query Syntax
:MARKer:XDELta?
The MARKer:XDELta? query returns the value difference between the
current X1 and X2 cursor positions.
Xdelta = (Value at X2 cursor) - (Value at X1 cursor)
Return Format
<value><NL>
<value> ::= difference value in NR3 format.
See Also • "Introduction to :MARKer Commands" on page 257
• ":MARKer:MODE" on page 258
• ":MARKer:X1Position" on page 259
• ":MARKer:X2Position" on page 261
• ":MARKer:X1Y1source" on page 260
• ":MARKer:X2Y2source" on page 262
NOTE
If the front-panel cursors are off, the marker position values are not defined. Make sure to
set :MARKer:MODE to MANual or WAVeform to put the cursors in the front-panel Normal
mode.

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English