Agilent Technologies InfiniiVision 5000 Series

606 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
7 Obsolete and Discontinued Commands
:MTESt:TRIGger:SOURce
(see page 658)
Command Syntax
:MTESt:TRIGger:SOURce <source>
<source> ::= CHANnel<n>
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :MTESt:TRIGger:SOURce command sets the channel to use as the
trigger.
Query Syntax
:MTESt:TRIGger:SOURce?
The :MTESt:TRIGger:SOURce? query returns the currently selected trigger
source.
Return Format
<source> ::= CHAN<n>
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
See Also • "Introduction to :MTESt Commands" on page 320
NOTE
The :MTESt:TRIGger:SOURce command is obsolete and is provided for backward
compatibility to previous oscilloscopes. Use the trigger source commands (see page 411)
instead.