Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 529
:WAVeform:XINCrement
(see page 658)
Query Syntax
:WAVeform:XINCrement?
The :WAVeform:XINCrement? query returns the x- increment value for the
currently specified source. This value is the time difference between
consecutive data points in seconds.
Return Format
<value><NL>
<value> ::= x-increment in the current preamble in 64-bit
floating point NR3 format
See Also • "Introduction to :WAVeform Commands" on page 502
• ":WAVeform:PREamble" on page 516
Example Code • "Example Code" on page 517
To Next Page
Loading...
