Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

476 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:TRIGger:SPI:SOURce:CLOCk
(see page 658)
Command Syntax
:TRIGger:SPI:SOURce:CLOCk <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital0,..,DIGital15} for the MSO models
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :TRIGger:SPI:SOURce:CLOCk command sets the source for the SPI
serial clock.
Query Syntax
:TRIGger:SPI:SOURce:CLOCk?
The :TRIGger:SPI:SOURce:CLOCk? query returns the current source for the
SPI serial clock.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 411
• ":TRIGger:SPI:CLOCk:SLOPe" on page 471
• ":TRIGger:SPI:CLOCk:TIMeout" on page 472
• ":TRIGger:SPI:SOURce:FRAMe" on page 478
• ":TRIGger:SPI:SOURce:DATA" on page 477

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English