Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 475
:TRIGger:SPI:PATTern:WIDTh
(see page 658)
Command Syntax
:TRIGger:SPI:PATTern:WIDTh <width>
<width> ::= integer from 4 to 32 in NR1 format
The :TRIGger:SPI:PATTern:WIDTh command sets the width of the SPI data
pattern anywhere from 4 bits to 32 bits.
Query Syntax
:TRIGger:SPI:PATTern:WIDTh?
The :TRIGger:SPI:PATTern:WIDTh? query returns the current SPI data
pattern width setting.
Return Format
<width><NL>
<width> ::= integer from 4 to 32 in NR1 format
See Also • "Introduction to :TRIGger Commands" on page 411
• ":TRIGger:SPI:PATTern:DATA" on page 474
• ":TRIGger:SPI:SOURce:DATA" on page 477
To Next Page
Loading...
