To Next Page

To Previous Page

Commands by Subsystem 5

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 441

:TRIGger[:EDGE]:LEVel

(see page 658)

Command Syntax

:TRIGger[:EDGE]:LEVel <level>

<level> ::= <level>[,<source>]

<level> ::= 0.75 x full-scale voltage from center screen in NR3 format

for internal triggers

<level> ::= ±(external range setting) in NR3 format

for external triggers

<source> ::= {CHANnel<n> | EXTernal}

<n>::={1|2|3|4}forthefour channel oscilloscope models

<n> ::= {1 | 2} for the two channel oscilloscope models

The :TRIGger[:EDGE]:LEVel command sets the trigger level voltage for the

active trigger source.

Query Syntax

:TRIGger[:EDGE]:LEVel? [<source>]

The :TRIGger[:EDGE]:LEVel? query returns the trigger level of the current

trigger source.

Return Format

See Also • "Introduction to :TRIGger Commands" on page 411

• ":TRIGger[:EDGE]:SOURce" on page 444

• ":EXTernal:RANGe" on page 226

NOTE

If the optional source is specified and is not the active source, the level on the active source

is not affected and the active source is not changed.

Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 5000 Series