Agilent Technologies InfiniiVision 5000 Series

196 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:CHANnel<n>:INVert
(see page 658)
Command Syntax
:CHANnel<n>:INVert <invert value>
<invert value> ::= {{1 | ON} | {0 | OFF}
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :CHANnel<n>:INVert command selects whether or not to invert the
input signal for the specified channel. The inversion may be 1
(ON/inverted) or 0 (OFF/not inverted).
Query Syntax
:CHANnel<n>:INVert?
The :CHANnel<n>:INVert? query returns the current state of the channel
inversion.
Return Format
<invert value><NL>
<invert value> ::= {0 | 1}
See Also • "Introduction to :CHANnel<n> Commands" on page 190