Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 301
:MEASure:STATistics:RESet
(see page 658)
Command Syntax
:MEASure:STATistics:RESet
This command resets the measurement statistics, zeroing the counts.
Note that the measurement (statistics) configuration is not deleted.
See Also • "Introduction to :MEASure Commands" on page 272
• ":MEASure:STATistics" on page 299
• ":MEASure:RESults" on page 291
• ":MEASure:STATistics:INCRement" on page 300
Example Code • "Example Code" on page 291
To Next Page
Loading...
