224 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:EXTernal:PROBe:STYPe
(see page 658)
Command Syntax
:EXTernal:PROBe:STYPe <signal type>
<signal type> ::= {DIFFerential | SINGle}
The :EXTernal:PROBe:STYPe command sets the external trigger probe
signal type (STYPe) to differential or single- ended when using the 113xA
Series probes and determines how offset is applied.
Query Syntax
:EXTernal:PROBe:STYPe?
The :EXTernal:PROBe:STYPe? query returns the current probe signal type
setting for the external trigger.
Return Format
<signal type><NL>
<signal type> ::= {DIFF | SING}
See Also • "Introduction to :EXTernal Trigger Commands" on page 218
NOTE
This command is valid only for the 113xA Series probes.
To Next Page
Loading...
