Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

386 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:SBUS:UART:COUNt:ERRor
(see page 658)
Query Syntax
:SBUS:UART:COUNt:ERRor?
Returns the UART error frame count.
Return Format
<frame_count><NL>
<frame_count> ::= integer in NR1 format
Errors • "- 241, Hardware missing" on page 617
See Also • ":SBUS:UART:COUNt:RESet" on page 387
• "Introduction to :SBUS Commands" on page 374
• ":SBUS:MODE" on page 383
• ":TRIGger:UART Commands" on page 485
NOTE
This command is only valid on 4 (analog) channel oscilloscope models when the
UART/RS-232 triggering and serial decode option (Option 232) has been licensed.

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English