To Next Page

To Previous Page

598 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

7 Obsolete and Discontinued Commands

:MEASure:VSTOp

(see page 658)

Command Syntax

:MEASure:VSTOp <vstop_argument>

<vstop_argument> ::= value for Y2 cursor

The :MEASure:VSTOp command moves the vertical marker 2 (Y2 cursor) to

the specified value corresponding to the selected source. The source can

be selected by the MARKer:X2Y2source command.

Query Syntax

:MEASure:VSTOp?

The :MEASure:VSTOp? query returns the current value of the Y2 cursor.

Return Format

<value> ::= value of the Y2 cursor in NR3 format

See Also • "Introduction to :MARKer Commands" on page 257

• "Introduction to :MEASure Commands" on page 272

• ":MARKer:Y1Position" on page 264

• ":MARKer:Y2Position" on page 265

• ":MARKer:YDELta" on page 266

• ":MARKer:X2Y2source" on page 262

• ":MEASure:SOURce" on page 297

• ":MEASure:TDELta" on page 587

• ":MEASure:TSTArt" on page 591

NOTE

The short form of this command, VSTO, does not follow the defined Long Form to Short

Form Truncation Rules (see page 660). The normal short form, VST, would be the same for

both VSTArt and VSTOp, so sending VST for the VSTOp command produces an error.

NOTE

The :MEASure:VSTOp command is an obsolete command provided for compatibility to

previous oscilloscopes. Use the :MARKer:Y2Position command (see page 265) instead.

Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 5000 Series