Agilent Technologies InfiniiVision 5000 Series

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 359
:SAVE:FILename
(see page 658)
Command Syntax
:SAVE:FILename <base_name>
<base_name> ::= quoted ASCII string
The :SAVE:FILename command specifies the source for any SAVE
operations.
Query Syntax
:SAVE:FILename?
The :SAVE:FILename? query returns the current SAVE filename.
Return Format
<base_name><NL>
<base_name> ::= quoted ASCII string
See Also • "Introduction to :SAVE Commands" on page 358
• ":SAVE:IMAGe[:STARt]" on page 360
• ":SAVE:SETup[:STARt]" on page 368
• ":SAVE:WAVeform[:STARt]" on page 369
• ":SAVE:PWD" on page 367
• ":RECall:FILename" on page 352
NOTE
This command specifies a file's base name only, without path information or an extension.