Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

358 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
Introduction to
:SAVE Commands
The :SAVE subsystem provides commands to save oscilloscope setups and
traces, screen images, and data.
:SAV is an acceptable short form for :SAVE.
Reporting the Setup
Use :SAVE? to query setup information for the SAVE subsystem.
Return Format
The following is a sample response from the :SAVE? query. In this case,
the query was issued following the *RST command.
:SAVE:FIL "";:SAVE:IMAG:AREA GRAT;FACT 0;FORM TIFF;INKS 0;PAL
MON;:SAVE:PWD "C:/setups/";:SAVE:WAV:FORM NONE;LENG 1000;SEGM CURR
:SAVE:SETup[:STARt]
[<file_spec>] (see
page 368)
n/a <file_spec> ::= {<internal_loc>
| <file_name>}
<internal_loc> ::= 0-9; an
integer in NR1 format
<file_name> ::= quoted ASCII
string
:SAVE:WAVeform[:STARt
] [<file_name>] (see
page 369)
n/a <file_name> ::= quoted ASCII
string
:SAVE:WAVeform:FORMat
<format> (see
page 370)
:SAVE:WAVeform:FORMat
? (see page 370)
<format> ::= {ALB | ASCiixy | CSV
| BINary | NONE}
:SAVE:WAVeform:LENGth
<length> (see
page 371)
:SAVE:WAVeform:LENGth
? (see page 371)
<length> ::= 100 to max. length;
an integer in NR1 format
:SAVE:WAVeform:SEGMen
ted <option> (see
page 372)
:SAVE:WAVeform:SEGMen
ted? (see page 372)
<option> ::= {ALL | CURRent}
Table 56 :SAVE Commands Summary (continued)
Command Query Options and Query Returns

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English