534 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:WAVeform:YREFerence
(see page 658)
Query Syntax
:WAVeform:YREFerence?
The :WAVeform:YREFerence? query returns the y- reference value for the
currently specified source. This value specifies the data point value where
the y- origin occurs. In this product, this is the data point value of the
center of the screen. It is undefined if the format is ASCii.
Return Format
<value><NL>
<value> ::= y-reference value in the current preamble in 32-bit
NR1 format
See Also • "Introduction to :WAVeform Commands" on page 502
• ":WAVeform:PREamble" on page 516
• ":WAVeform:YORigin" on page 533
Example Code • "Example Code" on page 517
To Next Page
Loading...
