To Next Page

To Previous Page

Commands by Subsystem 5

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 327

:MTESt:AMASk:YDELta

(see page 658)

Command Syntax

:MTESt:AMASk:YDELta <value>

<value> ::= Y delta value in NR3 format

The :MTESt:AMASk:YDELta command sets the vertical tolerance around

the waveform for the automasking feature. The absolute value of the

tolerance will be added and subtracted to vertical values of the waveform

to determine the boundaries of the mask.

The vertical tolerance value is interpreted based on the setting specified

by the :MTESt:AMASk:UNITs command; thus, if you specify 250-E3, the

setting for :MTESt:AMASk:UNITs is CURRent, and the current setting

specifies voltage in the vertical direction, the tolerance will be ±250 mV. If

the setting for :MTESt:AMASk:UNITs is DIVisions, the same Y delta value

will set the tolerance to ±250 millidivisions, or 1/4 of a division.

Query Syntax

:MTESt:AMASk:YDELta?

The :MTESt:AMASk:YDELta? query returns the current setting of the ∆Y

tolerance for automasking. If your computer program will interpret this

value, it should also request the current measurement system using the

:MTESt:AMASk:UNITs query.

Return Format

<value> ::= Y delta value in NR3 format

See Also • "Introduction to :MTESt Commands" on page 320

• ":MTESt:AMASk:UNITs" on page 325

• ":MTESt:AMASk:XDELta" on page 326

• ":MTESt:AMASk:SOURce" on page 324

• ":MTESt:SOURce" on page 349

Example Code • "Example Code" on page 320

Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 5000 Series