Agilent Technologies InfiniiVision 5000 Series

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 495
:TRIGger:UART:QUALifier
(see page 658)
Command Syntax
:TRIGger:UART:QUALifier <value>
<value> ::= {EQUal | NOTequal | GREaterthan | LESSthan}
The :TRIGger:UART:QUALifier command selects the data qualifier when
:TYPE is set to RDATa, RD1, RD0, RDX, TDATa, TD1, TD0, or TDX for the
trigger when in UART mode.
Query Syntax
:TRIGger:UART:QUALifier?
The :TRIGger:UART:QUALifier? query returns the current UART trigger
qualifier.
Return Format
<value><NL>
<value> ::= {EQU | NOT | GRE | LESS}
See Also • "Introduction to :TRIGger Commands" on page 411
• ":TRIGger:MODE" on page 417
• ":TRIGger:UART:TYPE" on page 498