Agilent Technologies InfiniiVision 5000 Series

More About Oscilloscope Commands 11
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 673
• :DATA (see page 477)
• :FRAMe (see page 478)
• :SWEep (see page 421)
• :TV (see page 479)
• :LINE (see page 480)
• :MODE (see page 481)
• :POLarity (see page 482)
• :SOURce (see page 483)
• :STANdard (see page 484)
• :TVMode (see page 613)
• :UART (see page 485)
• :BASE (see page 487)
• :BAUDrate (see page 488)
• :BITorder (see page 489)
• :BURSt (see page 490)
• :DATA (see page 491)
• :IDLE (see page 492)
• :PARity (see page 493)
• :QUALifier (see page 495)
• :POLarity (see page 494)
• :SOURce
• :RX (see page 496)
• :TX (see page 497)
• :TYPE (see page 498)
• :WIDTh (see page 499)
• :VIEW (see page 162)
• :WAVeform (see page 500)
• :BYTeorder (see page 507)
• :COUNt (see page 508)
• :DATA (see page 509)
• :FORMat (see page 511)
• :POINts (see page 512)
• :MODE (see page 514)
• :PREamble (see page 516)
• :SEGMented