Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 103
Query Syntax *ESE?
The *ESE? query returns the current contents of the Standard Event
Status Enable Register.
Return Format
<mask_argument><NL>
<mask_argument> ::= 0,..,255; an integer in NR1 format.
See Also • "Introduction to Common (*) Commands" on page 99
• "*ESR (Standard Event Status Register)" on page 104
• "*OPC (Operation Complete)" on page 108
• "*CLS (Clear Status)" on page 101
1 RQL Request Control Event when the device is requesting control. (Not
used.)
0 OPC Operation Complete Event when an operation is complete.
Table 30 Standard Event Status Enable (ESE) (continued)
Bit Name Description When Set (1 = High = True), Enables:
To Next Page
Loading...
