Agilent Technologies InfiniiVision 5000 Series

146 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
Query Syntax :OPEE?
The :OPEE? query returns the current value contained in the Operation
Status Enable register as an integer number.
Return Format
<value><NL>
<value> ::= integer in NR1 format.
See Also • "Introduction to Root (:) Commands" on page 124
• ":AER (Arm Event Register)" on page 125
• ":CHANnel<n>:PROTection" on page 203
• ":EXTernal:PROTection" on page 225
• ":OPERegister[:EVENt] (Operation Status Event Register)" on page 149
• ":OVLenable (Overload Event Enable Register)" on page 151
• ":OVLRegister (Overload Event Register)" on page 153
• "*STB (Read Status Byte)" on page 117
• "*SRE (Service Request Enable)" on page 115
5Wait
Trig
Wait Trig Event when the trigger is armed.
4 --- --- (Not used.)
3 Run Running Event when the oscilloscope is running (not
stopped).
2-0 --- --- (Not used.)
Table 40 Operation Status Enable Register (OPEE) (continued)
Bit Name Description When Set (1 = High = True), Enables: