Agilent Technologies InfiniiVision 5000 Series

150 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
Return Format <value><NL>
<value> ::= integer in NR1 format.
See Also • "Introduction to Root (:) Commands" on page 124
• ":CHANnel<n>:PROTection" on page 203
• ":EXTernal:PROTection" on page 225
• ":OPEE (Operation Status Enable Register)" on page 145
• ":OPERegister:CONDition (Operation Status Condition Register)" on
page 147
• ":OVLenable (Overload Event Enable Register)" on page 151
• ":OVLRegister (Overload Event Register)" on page 153
• "*STB (Read Status Byte)" on page 117
• "*SRE (Service Request Enable)" on page 115
• ":HWERegister[:EVENt] (Hardware Event Event Register)" on page 138
• ":HWEenable (Hardware Event Enable Register)" on page 134
• ":MTERegister[:EVENt] (Mask Test Event Event Register)" on page 143
• ":MTEenable (Mask Test Event Enable Register)" on page 141
3 Run Running The oscilloscope has gone from a stop state to
a single or running state.
2-0 --- --- (Not used.)
Table 42 Operation Status Event Register (continued)
Bit Name Description When Set (1 = High = True), Indicates: