Agilent Technologies InfiniiVision 5000 Series

152 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
Query Syntax :OVLenable?
The :OVLenable query returns the current enable mask value contained in
the Overload Event Enable Register.
Return Format
<enable_mask><NL>
<enable_mask> ::= integer in NR1 format.
See Also • "Introduction to Root (:) Commands" on page 124
• ":CHANnel<n>:PROTection" on page 203
• ":EXTernal:PROTection" on page 225
• ":OPEE (Operation Status Enable Register)" on page 145
• ":OPERegister:CONDition (Operation Status Condition Register)" on
page 147
• ":OPERegister[:EVENt] (Operation Status Event Register)" on page 149
• ":OVLRegister (Overload Event Register)" on page 153
• "*STB (Read Status Byte)" on page 117
• "*SRE (Service Request Enable)" on page 115
7 Channel 2 Fault Event when fault occurs on Channel 2 input.
6 Channel 1 Fault Event when fault occurs on Channel 1 input.
5 --- (Not used.)
4 External Trigger OVL Event when overload occurs on External Trigger
input.
3 Channel 4 OVL Event when overload occurs on Channel 4 input.
2 Channel 3 OVL Event when overload occurs on Channel 3 input.
1 Channel 2 OVL Event when overload occurs on Channel 2 input.
0 Channel 1 OVL Event when overload occurs on Channel 1 input.
Table 43 Overload Event Enable Register (OVL) (continued)
Bit Description When Set (1 = High = True), Enables: