Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

What's New 1
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 21
Changed
Commands
Obsolete
Commands
Command Differences
:CHANnel<n>:LABel (see page 197) Labels can now be up to 10 characters.
:DISPlay:LABList (see page 214) Labels can now be up to 10 characters.
:MARKer:MODE (see page 258) You can now select the WAVeform tracking
cursors mode.
:RECall:PWD (see page 355) You can set the present working directory in
addition to querying for this information.
:SAVE:IMAGe[:STARt] (see page 360) The file extension specified will change the
:SAVE:IMAGe:FORMat setting if it is a valid
image file extension.
:SAVE:PWD (see page 367) You can set the present working directory in
addition to querying for this information.
:SAVE:WAVeform[:STARt] (see page 360) The file extension specified will change the
:SAVE:WAVeform:FORMat setting if it is a valid
waveform file extension.
:TRIGger:CAN:SIGNal:BAUDrate (see
page 429)
The baud rate value can now be set in 100 b/s
increments.
:TRIGger:LIN:SIGNal:BAUDrate (see page 465) The baud rate value can now be set in 100 b/s
increments.
:TRIGger:UART:BAUDrate (see page 488) The baud rate value can now be set in 100 b/s
increments and the maximum baud rate is now
3Mb/s.
:TRIGger:UART:DATA (see page 491) You can now specify the data value using a
quoted ASCII character.
Obsolete Command Current Command Equivalent Behavior Differences
:MTESt:AMASk:{SAVE |
STORe} (see page 599)
:SAVE:MASK[:STARt] (see
page 366)
:MTESt:AVERage (see
page 600)
:ACQuire:TYPE AVERage (see
page 177)
:MTESt:AVERage:COUNt (see
page 601)
:ACQuire:COUNt (see
page 167)
:MTESt:LOAD (see page 602) :RECall:MASK[:STARt] (see
page 354)
:MTESt:RUMode (see
page 603)
:MTESt:RMODe (see
page 337)
:MTESt:RUMode:SOFailure
(see page 604)
:MTESt:RMODe:FACTion:STO
P (see page 340)

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English