To Next Page

To Previous Page

Commands by Subsystem 5

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 273

When making measurements in the zoomed (delayed) time base mode

(:TIMebase:MODE WINDow), the oscilloscope will attempt to make the

measurement inside the zoomed sweep window. If the measurement is an

average and there are not three edges, the oscilloscope will revert to the

mode of making the measurement at the start of the main sweep.

When the command form is used, the measurement result is displayed on

the instrument. When the query form of these measurements is used, the

measurement is made one time, and the measurement result is returned

over the bus.

Measurements are made on the displayed waveforms specified by the

:MEASure:SOURce command. The MATH source is an alias for the

FUNCtion source.

Not all measurements are available on the FFT (Fast Fourier Transform).

Reporting the Setup

Use the :MEASure? query to obtain setup information for the MEASure

subsystem. (Currently, this is only :MEASure:SOURce.)

Return Format

The following is a sample response from the :MEASure? query. In this

case, the query was issued following a *RST command.

:MEAS:SOUR CHAN1,CHAN2;STAT ON

Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 5000 Series