280 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
Vtop. If you want to move the delay measurement point nearer to Vtop or
Vbase, you must change the threshold values with the :MEASure:DEFine
THResholds command.
Return Format
<value><NL>
<value> ::= floating-point number delay time in seconds in NR3 format
See Also • "Introduction to :MEASure Commands" on page 272
• ":MEASure:DEFine" on page 276
• ":MEASure:PHASe" on page 288
To Next Page
Loading...
