Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 515
The :WAVeform:POINts:MODE? query returns the current points mode.
Setting the points mode will affect what data is transferred. See the
discussion above.
Return Format
<points_mode><NL>
<points_mode> ::= {NORMal | MAXimum | RAW}
See Also • "Introduction to :WAVeform Commands" on page 502
• ":ACQuire:POINts" on page 170
• ":WAVeform:DATA" on page 509
• ":WAVeform:VIEW" on page 528
• ":WAVeform:PREamble" on page 516
• ":WAVeform:POINts" on page 512
• ":TIMebase:MODE" on page 402
• ":ACQuire:TYPE" on page 177
• ":ACQuire:COUNt" on page 167

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English