Agilent Technologies InfiniiVision 5000 Series

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 517
See Also • "Introduction to :WAVeform Commands" on page 502
• ":ACQuire:COUNt" on page 167
• ":ACQuire:POINts" on page 170
• ":ACQuire:TYPE" on page 177
• ":DIGitize" on page 132
• ":WAVeform:COUNt" on page 508
• ":WAVeform:DATA" on page 509
• ":WAVeform:FORMat" on page 511
• ":WAVeform:POINts" on page 512
• ":WAVeform:TYPE" on page 526
• ":WAVeform:XINCrement" on page 529
• ":WAVeform:XORigin" on page 530
• ":WAVeform:XREFerence" on page 531
• ":WAVeform:YINCrement" on page 532
• ":WAVeform:YORigin" on page 533
• ":WAVeform:YREFerence" on page 534
Example Code
' GET_PREAMBLE - The preamble block contains all of the current
' WAVEFORM settings. It is returned in the form <preamble_block><NL>
' where <preamble_block> is:
' FORMAT : int16-0=BYTE, 1 = WORD, 4 = ASCII.
<RULJLQ9
<LQFUHPHQW
YROWDJHRI9VWHS
<UHIHUHQFH 9VWHSV
;RULJLQW
;LQFUHPHQWW WLPHEHWZHHQVXFFHVVLYHSRLQWV
;UHIHUHQFH 
'HOD\ SRLQWV;LQFUHPHQW;RULJLQ
2IIVHW
9VWHSV
LIIRUPDW :25'
LIIRUPDW %<7(