Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

554 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
6 Commands A-Z
• ":FUNCtion:GOFT:SOURce2" on page 235
• ":FUNCtion:SOURce2" on page 242
• SPAN, ":FUNCtion:SPAN" on page 243
• SPI Commands:
• ":SBUS:SPI:WIDTh" on page 384
• ":TRIGger:SPI Commands" on page 470
• SRATe, ":ACQuire:SRATe" on page 176
• "*SRE (Service Request Enable)" on page 115
• STANdard Commands:
• ":TRIGger:LIN:STANdard" on page 467
• ":TRIGger:TV:STANdard" on page 484
• STARt Commands:
• ":CALibrate:STARt" on page 184
• ":HARDcopy:STARt" on page 255
• ":MTESt:{STARt | STOP}" on page 605
• ":RECall:IMAGe[:STARt]" on page 353
• ":RECall:MASK[:STARt]" on page 354
• ":RECall:SETup[:STARt]" on page 356
• ":SAVE:IMAGe[:STARt]" on page 360
• ":SAVE:MASK[:STARt]" on page 366
• ":SAVE:SETup[:STARt]" on page 368
• ":SAVE:WAVeform[:STARt]" on page 369
• STATistics Commands:
• ":MEASure:STATistics" on page 299
• ":MEASure:STATistics:INCRement" on page 300
• ":MEASure:STATistics:RESet" on page 301
• STATus Commands:
• ":CALibrate:STATus" on page 185
• ":STATus" on page 159
• "*STB (Read Status Byte)" on page 117
• STOP Commands:
• ":MTESt:RMODe:FACTion:STOP" on page 340
• ":MTESt:{STARt | STOP}" on page 605
• ":STOP" on page 160
• STORe, ":MTESt:AMASk:{SAVE | STORe}" on page 599

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English