To Next Page

To Previous Page

666 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

11 More About Oscilloscope Commands

• :HWERegister

• :CONDition (Hardware Event Condition Register) (see page 136)

• [:EVENt] (Hardware Event Event Register) (see page 138)

• :MARKer (see page 256)

• :MODE (see page 258)

• :X1Position (see page 259)

• :X1Y1source (see page 260)

• :X2Position (see page 261)

• :X2Y2source (see page 262)

• :XDELta (see page 263)

• :Y1Position (see page 264)

• :Y2Position (see page 265)

• :YDELta (see page 266)

• :MEASure (see page 267)

• :CLEar (see page 274)

• :COUNter (see page 275)

• :DEFine (see page 276)

• :DELay (see page 279)

• :DUTYcycle (see page 281)

• :FALLtime (see page 282)

• :FREQuency (see page 283)

• :NWIDth (see page 284)

• :OVERshoot (see page 285)

• :PERiod (see page 287)

• :PHASe (see page 288)

• :PREShoot (see page 289)

• :PWIDth (see page 290)

• :RISetime (see page 294)

• :RESults (see page 291)

• :SDEViation (see page 295)

• :SHOW (see page 296)

• :SOURce (see page 297)

• :STATistics (see page 299)

• :INCRement (see page 300)

• :RESet (see page 301)

Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 5000 Series