Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

682 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
12 Programming Examples
/* Clear the interface. */
iclear(id);
iremote(id);
}
initialize();
/* The extras function contains miscellaneous commands that do not
* need to be executed for the proper operation of this example.
* The commands in the extras function are shown for reference
* purposes only.
*/
/* extra(); */ /* <-- Uncomment to execute the extra function */
capture();
analyze();
/* Close the device session to the instrument. */
iclose(id);
printf ("Program execution is complete...\n");
/* For WIN16 programs, call _siclcleanup before exiting to release
* resources allocated by SICL for this application. This call is
* a no-op for WIN32 programs.
*/
_siclcleanup();
}
/*
* initialize
* ------------------------------------------------------------------
* This function initializes both the interface and the oscilloscope
* to a known state.
*/
void initialize (void)
{
/* RESET - This command puts the oscilloscope in a known state.
* Without this command, the oscilloscope settings are unknown.
* This command is very important for program control.
*
* Many of the following initialization commands are initialized
* by this command. It is not necessary to reinitialize them
* unless you want to change the default setting.
*/
iprintf(id, "*RST\n");
/* Write the *IDN? string and send an EOI indicator, then read
* the response into buf.
ipromptf(id, "*IDN?\n", "%t", buf);
printf("%s\n", buf);
*/
/* AUTOSCALE - This command evaluates all the input signals and
* sets the correct conditions to display all of the active signals.

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English