Send document comments to nexus7k-feedback-doc@cisco.com
2-450
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PIM Messages
Error Message PIM-3-PIM_CIB Format: Couldn't find PIM VRF for %s
Explanation PIM failed to obtain its VRF information block.
Parameters: Interface ...
Recommended Action Dump core, and and and then restart component.
Error Message PIM-3-PIM_EXISTS Format: PIM is already running, process exiting
Explanation Another PIM process is already running, this process will shut down.
Recommended Action No action is required.
Error Message PIM-3-PIM_INIT Format: PIM init failed: %s
Explanation PIM process initialization has failed.
Parameters: Component Name ...
Recommended Action Dump core, and and and then restart component.
Error Message PIM-3-POLICY_INVALID_BINDACK Format: Invalid RPM bind ack in %s
Explanation PIM received invalid policy response from RPM.
Recommended Action No action is required.
Error Message PIM-3-POLICY_INVALID_TYPE Format: Invalid RPM type %d in %s
Explanation PIM received invalid policy-type from RPM.
Recommended Action No action is required.
Error Message PIM-3-PSS_FAILED Format: PSS operation %s failed
Explanation PIM process failed in a PSS operation.
Parameters: Operation Name ...
Recommended Action No action is required.
Error Message PIM-3-PT_ADD Format: Couldn't add %s to local PT
Explanation PIM failed to update the local route-table entry.
Parameters: Addresses ...
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General
