Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-484
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PLATFORM Messages
Error Message PLATFORM-2-PFM_MODULE_POWER_ON: Manual power-on of [chars] from
Command Line Interface
Explanation User initiated a module power-on from the CLI.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message PLATFORM-2-PFM_MODULE_POWER_ON: Manual power-on of Module [dec] from
Command Line Interface
Explanation User initiated a module power-on from the CLI.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message PLATFORM-2-PFM_MODULE_RESET: Manual restart of Module [dec] from
Command Line Interface
Explanation User initiated a module reload from the CLI.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message PLATFORM-2-PFM_NETBOOT_DISABLE: Netboot for supervisor module in slot
[dec] is disabled due to incompatible platform
Explanation Standby supervisor failed to power up.
Recommended Action Try to replace the standby supervisor.
Error Message PLATFORM-2-PFM_PWR_MGMT_EPLD_VER_MISMATCH: Module [dec] Pwr Mgmt Epld
(Version-[dec]) needs to be upgraded
Explanation Using a wrong version of Epld version can result in unexplainable behavior.
Recommended Action Upgrade Power Managment EPLD.
Error Message PLATFORM-2-PFM_STDBY_POWERUP_FAIL: standby supervisor failed to
powerup
Explanation Standby supervisor failed to power up.
Recommended Action Try to replace the standby supervisor.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English