Send document comments to nexus7k-feedback-doc@cisco.com
2-645
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
SVC Messages
Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
SS_EID_EC_ER_IOP_STOPPED_DUE_TO_SIGNAL ) Internal error - signal caused stop
[chars]
Explanation The IO process stopped because of a signal received. Node was warmstarted due to this
error.
Recommended Action 1. Ensure that the software is at the latest level on the cluster. 2. Contact the
Cisco Technical Assistance Center (TAC) through the Cisco Support web site
http://www.cisco.com/tac.
Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
SS_EID_EC_ER_IOP_TERMINATED_ABNORMALLY ) Internal error - abnormal exit [chars]
Explanation The IO process exited abormally. Node was warmstarted due to this error.
Recommended Action 1. Ensure that the software is at the latest level on the cluster. 2. Contact the
Cisco Technical Assistance Center (TAC) through the Cisco Support web site
http://www.cisco.com/tac.
Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
SS_EID_EC_ER_OPEN_MSG_QUEUE_FAILED ) Internal error - message queue [chars]
Explanation The process was unable to open the needed message queue. Node was rebooted due to
this error.
Recommended Action If this error is repeated continously, 1. Re-install the code on the node. The
node will then have to be removed and re-added back to the cluster. 2. Ensure that the software is at
the latest level on the cluster. If not, upgrade the cluster and if necessary repeat step 1 with the latest
level of code. 3. If the error continues, ask IBM Product Support for assistance.
Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
SS_EID_EC_ER_PTHREAD_CREATE_FAILED ) Internal error - threads [chars]
Explanation The process was unable to create the needed threads. Node was rebooted due to this
error.
Recommended Action If this error is repeated continously, 1. Re-install the code on the node. The
node will then have to be removed and re-added back to the cluster. 2. Ensure that the software is at
the latest level on the cluster. If not, upgrade the cluster and if necessary repeat step 1 with the latest
level of code. 3. If the error continues, ask IBM Product Support for assistance.
Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
SS_EID_EC_ER_UNKNOWN_MESSAGE_TYPE ) Internal error - message type [chars]
Explanation Node was rebooted due to internal logic error.
Recommended Action 1. Ensure that the software is at the latest level on the cluster. 2. Contact the
Cisco Technical Assistance Center (TAC) through the Cisco Support web site
http://www.cisco.com/tac.
To Next Page
Loading...
Need help?
General
